Insert your code with short explanation of each part. Write the code to setup the pins 8, 9, and 10 of the board as digital outputs and sequentially turn on each LED for 1/3 of a second. Implement the circuit and insert screen shot of your setup. You access it by logging in to Tinkercad and clicking.

Assuming 2 V forward voltage for all the LEDs, calculate the required current limiting resistors and write your calculations. 1.Tinkercad circuits is a fully functional Arduino+Circuit simulator that runs in your web browser. The Arduino UNO digital outputs will be +5V at HIGH level and you should use current limiting resistors to drive the LEDs properly. Using a small breadboard, connect 3 LEDs (Red, Yellow, and Green) to the Arduino board pin 9, 10 and 11. Set the delay value to have the LED on for 0.1 s and off for 0.9 s. Run the code and explain how it blinks the LED. Parameters: ms: the number of milliseconds to pause. Simulate and programme Arduino and breadboard components. dedax.cms) Description: Pauses the program forthe amount of time (in milliseconds) specified as parameter. Circuits empowers you to bring your ideas to life with free, easy-to-use online tools. digitalWrite(pin, value) Description: Write a HIGH or a LOW value to a digital pin. Parameters: pin: the Arduino pin numberto set the mode of. You will see the Blink LED code: KZ Code Start Simulation Export Share Text 1 (Arduino Uno RS) 1 void setup pode (13, OUTPUT) 6 void loop 10 11 12 digitalnite (1), NON delay(1000) // wait for 1000 millisecond(s) digitalnite 13,LOW) delay(1000) // Wait for 1000 seconds) Syntax of the used commands in this very basic code are as follows: RinMode(pin, mode) Description: Write a HIGH or a LOW value to a digital pin. Open the code and change the view to text only. Choose Circuits and open a new circuit simulation.

Part 1: Digital Outputs In this lab we will use Tinker Cad - Circuit simulation (Please register for an account.

Circuit lab arduino simulator